Remove/Install Cigarette Lighter - AR54.10-P-0030LW

Model 205, 213, 238, 253, 293 

with code 301 (Package SMOKER) 

Courtesy of MERCEDES-BENZ USA

Shown on model 205 

	Remove/install
	Switch off ignition and store transmitter key outside of transmission range (min. 2 m).
2	Open flap (7).
3	Pull insert (1) out of housing (3).
4	Release housing (3) using pliers (2) and pull out of clamping sleeve (4) far enough to gain access to the electrical connector (5).	The studs of the pliers (2) must engage in the cutouts of the housing (3) (arrows A).
		Pliers	Fig 1
5	Disconnect electrical connector (5) and remove housing (3).
6	Unclip spring pin (4) from storage compartment with ashtray (6) by pushing back the two catch hooks, and then remove it.	Check for correct installation position of spring pin (4).
7	Install in the reverse order.

Fig 1: Identifying Pliers (169 589 00 37 00)

Courtesy of MERCEDES-BENZ USA