LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2017 >> C300 Base, 2D Convertible >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Electrical System, Equipment & Instruments - 205 Chassis - 2 Of 5 >> Testing & Repair >> Disconnect/Connect Battery Ground Line - AR54.10-P-0003LW

Disconnect/Connect Battery Ground Line - AR54.10-P-0003LW

Model 205 

Model 213 

Model 253 

Shown on model 213 except code B01 (48V technology) 

G12938255Courtesy of MERCEDES-BENZ USA

Shown on model 205.386 except code U98 (LITHIUM-ION STARTER BATTERY (LISB)) up to model year 2019 

G12938256Courtesy of MERCEDES-BENZ USA
WARNING Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. No parts of the body or limbs should be within the operating area when the components are moving. AS00.00-Z-0011-01A
  Risk of death  when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC) Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines. AS00.00-Z-0035-01A
  Risk of fire  /risk of explosion due to short circuit and escaping oxyhydrogen gas. Risk of (burn) injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte/mist, short circuit and arcing. Risk of poisoning  caused by swallowing battery electrolyte or absorption of lead through the skin or body orifices. Risk of death  due to voltage U >= 30 V AC and U >= 60 V DC. No fires, sparks, open flames, or smoking. Wear acid-resistant gloves, clothing, and glasses. Pour battery acid only into suitable and appropriately marked containers. AS54.10-Z-0001-01A 
  General information on handling vehicles with high-voltage on-board electrical system and/or lithium-ion battery and/or gaseous-fuel drive system   AH00.00-Z-0300-01A
  Notes on battery   AH54.10-P-0001-01A
  Notes on HANDS-FREE ACCESS   AH80.61-P-0001-01A
  Disconnect, connect     
1 Open hood.    
2 Switch off ignition and store transmitter key outside of transmission range (min. 2 m). NOTES
All electrical consumers must be switched off. Otherwise they or the on-board electrical system battery (G1) may be damaged when disconnecting/connecting the ground line (3).
 
3.1 Expose on-board electrical system battery (G1) in trunk or load compartment. Model 205 (except
205.012/013/047/053/054/147/212/213/247/253) with code B01 (48V technology)
Model 205.012/047/147/212/247
Model 205.08/38
except code B01 (48V technology)
except code U98 (LITHIUM-ION STARTER BATTERY (LISB))
Model 213, 253
with code B01 (48V technology)
 
3.2 Remove cover (1) and expose on-board electrical system battery (G1). Model 205 (except
205.012/013/047/053/054/08/147/212/213/247/253/38)
except code B01 (48V technology)
Model 205.013/053/054/213/253
Model 205.08/38
with code U98 (LITHIUM-ION STARTER BATTERY (LISB))
except code B01 (48V technology)
Model 213, 253
except code B01 (48V technology)
 
REFER TO MAINTENANCE   Model 205 (except 205.012/013/047/053/054/08/147/212/213/247/253/38)
except code B01 (48V technology)
Model 205.013/053/054/213/253
Model 205.08/38
with code U98 (LITHIUM-ION STARTER BATTERY (LISB))
except code B01 (48V technology)
AP83.00-P-8381B
REFER TO MAINTENANCE   Model 213, 253
except code B01 (48V technology)
AP83.00-P-8381C
4 Disconnect charger of on-board electrical system battery (G1). When an external charger is connected.  
5 Disconnect diagnostic unit. If a diagnostic device is connected.  
REFER TO SELF-DIAGNOSTIC SYSTEMS     AD00.00-P-2000-04B
6 Undo nut (2) and remove ground line (3) from negative pole of on-board electrical system battery (G1). TORQUE SPECIFICATION Nut, electrical line to negative terminal/positive terminal of on-board electrical system battery *BA54.10-P-1004-01A 
7 Using a diode test lamp, check on-board electrical system for voltage between positive line of on-board electrical system battery (G1) and disconnected ground line (3). Model 205.012/013/047/053/054/147/212/213/247/253
Model 213.016/050/053/054/216
Model 253.311/353/354/911/953/954
IMPORTANT If the diode test lamp lights up, the on-board electrical system is still active because of a defect in the electrical system.
If the diode test lamp lights up,

Detach ground line from additional battery and check the on-board electrical system after completing the work.
 
    Model 205.012/013/047/053/054/147/212/213/247/253
Model 253.311/353/354/911/953/954
AR54.10-P-0007LW 
    Model 213.016/050/053/054/216 AR54.10-P-0007LHV
8 Connect in reverse order.    
INSPECT Check     
9 Check time display. In the event of a problem,
↓ 
set proper time.
 
BATTERY

Number Designation Model 205 Model 213
BA54.10-P-1004-01A Nut, electrical line to negative terminal/positive terminal of on-board electrical system battery Nm 6 6
BATTERY

Number Designation Model 253
BA54.10-P-1004-01A Nut, electrical line to negative terminal/positive terminal of on-board electrical system battery Nm 6