Subsequently Modify Plug Housing For SD Card Navigation Electrical Wiring Harness - AN82.85-P-0007-08LW

Model 205.0/2/3/4 

with code 154 (CHANGE FROM HU-ENTRY FROM MELCO TO PANASONIC/OPTIMI. HW) 

Fig 1: Identifying New Passenger Car Wiring Harness Repair Kit (220 589 04 99 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying MQS Blade (220 589 01 99 60)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Blade Holder With Clamping Pliers (220 589 01 99 50)

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying Wiring Harness Repair Kit, Basic (000 589 13 99 00)

Courtesy of MERCEDES-BENZ USA

1. Lift up catch tab (10.1) of blue supporting body (10).

   The blue supporting body (10) was connected to the USB electrical connector in the front stowage compartment.

2. Pull black 8-pin connector socket (10.2) in direction of arrow and out of the blue supporting body (10).
3. Remove secondary fuse (10.3) from blue supporting body (10).

   Courtesy of MERCEDES-BENZ USA

4. Catch tab (10.4) of the blue supporting body (10).
5. Pull connector socket (14) in direction of arrow and out of the blue supporting body (10).

   Courtesy of MERCEDES-BENZ USA

6. Remove contact springs of red line (RD), brown line (BN) and white/yellow line (WH/YE) from black 8-pin connector socket (9).

   To remove the use the blade holder with collet as well as the blade MQS from the basic wiring harness repair kit or supplementary passenger car wiring harness repair kit.

   Courtesy of MERCEDES-BENZ USA

7. Remove secondary lock se (15.1) from violet connector housing (15).
8. Install contact spring of white/yellow line (WH/YE) into contact cavity "1"  of the violet connector housing (15).

   Contact cavity "1"  of the violet connector housing (15) is labeled.

9. Mount secondary lock (15.1) onto violet connector housing (15).
10. Remove secondary locks (16.1, 16.2) from white connector housing (16).
11. Install contact spring of red line (RD) into contact cavity "1"  of white connector housing (16).

    Contact cavity "1"  of the white connector housing (16) is labeled.

12. Install contact spring of brown line (BN) into contact cavity "2"  of white connector housing (16).

    Contact cavity "2"  of the white connector housing (16) is labeled.

13. Install connector socket (14) into large contact cavity block of white connector housing (16).

    The connector socket (14) and the large contact cavity block of the white connector housing (16) are shape coded.

14. Mount secondary locks (16.1, 16.2) onto white connector housing (16).

    Courtesy of MERCEDES-BENZ USA