Remove/Install Side Paneling In Trunk - AR68.30-P-4800LWR

Model 205.4, 238.4 

Courtesy of MERCEDES-BENZ USA

Shown on right trim (8) on model 205.4 

Shown on left trim (8) on model 238.4 with code 550 (Trailer hitch) 

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on HANDS-FREE ACCESS		AH80.61-P-0001-01A
	Remove/install
1	Remove cover (2).		AR68.30-P-4660LWR
2	Remove rear-end center-section trim.		AR68.30-P-4785LW
3	Unscrew nuts (11).
4	Remove tie-down eye (6).	Screw/bolt for tie-down eye	*BA68.50-P-1001-03I
5	Separate partition (7) from trim (8) and place behind guide (9).	Pay attention to installation position.
6	Remove hook (12).	Model 238.4
7	Remove retaining clips (4).	Dismantling tool	Fig 1
8	Unhook trim (8) from guide (9) and release.	Installation:  Ensure that paneling (5), seal (10) as well as retaining bracket of net (3) are installed correctly.
9	Disconnect electrical connector from left trunk rear seat backrest release button (S54/9) or right trunk rear seat backrest release button (S54/10).
10	Disconnect electrical connector for right trunk lamp (E18/4).	When removing right paneling (8).
11	Disconnect electrical connector for left trunk lamp (E18/5).	Model 238.4 When removing left paneling (8).
12	Disconnect electrical connector for trailer hitch release switch (S62/24).	Model 205.4, 238.4 with code 550 (Trailer coupling) When removing left paneling (8).
13	Remove trim (8).
14	Install in the reverse order.
	Check
15	Perform function test for corresponding component parts.

Fig 1: Identifying Dismantling Tool (000 589 95 63 00)

Courtesy of MERCEDES-BENZ USA