Remove, install mechanical front glass roof for panoramic sliding roof - AR77.21-P-0510NKB
MODEL 242 with CODE 413 (Automatic panoramic sliding sunroof)
MODEL 246 with CODE 413 (Automatic panoramic sliding sunroof)
MODIFICATION NOTES
| 12.8.15 | Method change | Work step 12 and 13 |
Shown on right side of panoramic roof
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Remove/install | |||
| 1 | Remove front panoramic roof | AR77.21-P-0500NKB | |
It is necessary to replace all parts present in the repair kit, even if only one part of the panoramic roof mechanical system is defective. Otherwise proper function of the panoramic roof is not permanently ensured. |
|||
| 2 | Move panoramic sliding roof switch in "OPEN" direction and adjust panoramic roof mechanical system until left and right bottom front gates (5) are accessible | ||
| 3 | Remove seal (4) in area of left and right lower front gate (5) | ||
| 4 | Unscrew bolt (6) and remove left and right front lower gate (5) | ||
| 5 | Actuate panoramic sliding roof switch in "CLOSE" direction and adjust panoramic roof mechanical system until the sliding pins (8) on the left and right top gate (1) make contact to the cutout (arrow) on the corresponding guide rail (7) | ||
| 6 | Remove left and right upper gate (1) together with control slider (2) toward front and remove upward from guide rails (7) | ||
| 7 | Unscrew nut (10) on left and right side of panoramic roof and remove washer | ||
| 8 | Unscrew bolt (11) on left and right side of panoramic roof | ||
| 9 | Remove left and right upper gate (1), control slider (2) and left and right lower rear gate (9) | ||
| 10 | Move panoramic sliding roof switch in "CLOSE" direction and adjust panoramic roof mechanical system until left and right bottom drive slider (3) are completely moved toward front | ||
| 11 | Position left and right drive slider (3) in front area in guide rails (7) at an angle | ||
| 12 | Remove overhead control panel | AR82.20-P-1000NKB | |
| 13 | Adjust mechanical components on panoramic sliding roof manually with suitable tool at adjusting screw on panoramic sliding roof motor until left and right driver sliders (3) are completely moved toward front. | ||
| 14 | Remove drive slider (3) form guide rails (7) | ||
| 15 | Install in the reverse order |