Remove/install fan for lamp unit - AR82.10-P-4742NKB
MODEL 246 with CODE 631 (Headlamps, LED, static, left-hand traffic)
MODEL 246 with CODE 632 (Headlamps, LED, static, right-side traffic)
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove | |||
| 1 | Remove left front lamp unit (E1) or right front lamp unit (E2) | AR82.10-P-4730NKB | |
| Risk of injury caused by burns to skin and eyes, risk of poisoning caused by inhaling vapors when working with plastics | Wear protective gloves and safety glasses. Ensure that the work area is adequately ventilated. | AS00.00-Z-0001-02A | |
| 2.1 | Cut open housing of left front lamp unit (E1) or right front lamp unit (E2) inside bar (arrow A), along notch | Cap (4) is not installed. | |
| 000 588 03 84 00 Hot knife | WS82.00-P-0026B | ||
Carefully cut open housing of left front lamp unit (E1) or right front lamp unit (E2). Otherwise components in housing of left front lamp unit (E1) or right front lamp unit (E2) may be damaged. Do not damage bar (arrow A). Otherwise housing of left front lamp unit (E1) or right front lamp unit (E2) may be leaky. |
|||
| 2.2 | Remove cap (4) | Cap (4) is installed. |
|
| 3 | Disconnect electrical connector (1) | ||
| 4 | Loosen mounting clamp (2) and remove left front lamp unit fan motor 1 (E1m4) or right front lamp unit fan motor 1 (E2m4) | ||
| Install | |||
| 5 | Install left front lamp unit fan motor 1 (E1m4) or right front lamp unit fan motor 1 (E2m4) | ||
| 6 | Connect electrical connector (1) | ||
| 7 | Place cap (4) on opening in housing of left front lamp unit (E1) or right front lamp unit (E2) and screw in place with screws/bolts (3). | The cap (4) must be positioned exactly on the bar (arrow A). Otherwise, the housing of the left front lamp unit (E1) or the right front lamp unit (E2) may start to leak. |
|
| 8 | Install left front lamp unit (E1) and right front lamp unit (E2) | AR82.10-P-4730NKB |