Remove/install bulbs of headlamp unit - AR82.10-P-1201NKD
MODEL 117, 176, 242, 246 with CODE 621 (Intelligent Light System (left-hand traffic))
without CODE 614 (Bi-xenon headlamp unit)
without CODE 615 (Bi-xenon headlamp unit)
without CODE 618 (Bi-xenon headlamps)
without CODE 622 (Intelligent Light System (right-hand traffic))
MODEL 117, 176, 242, 246 with CODE 622 (Intelligent Light System (right-hand traffic))
without CODE 614 (Bi-xenon headlamp unit)
without CODE 615 (Bi-xenon headlamp unit)
without CODE 618 (Bi-xenon headlamps)
without CODE 621 (Intelligent Light System (left-hand traffic))
Shown on the left front lamp unit (E1)
| Risk of injury due to fan starting unexpectedly | Do not reach into the rotation or hazard area of the fan. Wear closed and close-fitting work clothes. | AS20.40-Z-0001-01A | |
| Risk of death due to high voltage in xenon headlamps. Risk of explosion/risk of fire caused by highly flammable materials in the vicinity of damaged xenon bulbs. Risk of injury caused by UV light, hot components at xenon headlamps and glass splinters produced by bursting xenon bulbs. Risk of poisoning caused by inhalation of mercury vapors and by toxic salts and mercury compounds being ingested or coming into contact with skin | Do not touch parts conducting high voltage. Persons with active electronic implants (e.g. cardiac pacemakers) must never work on xenon headlamps. Switch off the entire lighting system. Wear insulated safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure sufficient ventilation in the working area. | AS82.10-Z-0001-01A | |
| Remove/install | |||
| 1 | Switch off exterior lights | ||
| 2 | Switch off ignition and remove transmitter key from electronic ignition lock control unit | ||
| 3 | Open service flap in front axle fender liner, left and/or right | ||
| 4 | Detach housing cover (1) | When removing left xenon bulb with integrated ignition module (E1e10) or right xenon bulb with integrated ignition module (E2e10). | |
| 5 | Detach housing cover (2) | When removing left cornering light (E1e9) or right cornering light (E2e9). | |
| 6 | Remove left cornering lights (E1e9) or right cornering lights (E2e9) | When removing left cornering light (E1e9) or right cornering light (E2e9). Do not touch bulbs of left cornering light (E1e9) or right cornering light (E2e9) with your bare fingers; use a soft cloth free of oil and grease. Otherwise the bulb will be damaged by overheating. Pull left cornering lights (E1e9) or right cornering lights (E2e9) out of cornering light socket (4). |
|
| 7 | Remove left xenon bulb with integrated ignition module (E1e10) or right xenon bulb with integrated ignition module (E2e10) | When removing left xenon bulb with integrated ignition module (E1e10) or right xenon bulb with integrated ignition module (E2e10). Do not touch bulbs of left xenon bulb with integrated ignition module (E1e10) or right xenon bulb with integrated ignition module (E2e10) with your bare fingers; use a soft cloth free of oil and grease. Otherwise the bulb will be damaged by overheating. Carefully pull left xenon bulb with integrated ignition module (E1e10) or right xenon bulb with integrated ignition module (E2e10) out of reflector. Otherwise there is a risk of breakage of the bulb. |
|
| 8 | Install in the reverse order |