Remove/install taillamp - AR82.10-P-4905NKB

MODEL 246 

MODEL 242 

Shown on right side of vehicle 

Fig 1: Identifying Taillamp Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove cover (2) at left or right
2	Disconnect electrical connector (3)
3	Unscrew nuts (4)
4	Route left rear lamp unit (E3) or right rear lamp unit (E4) to rear (arrow) and out of the lower guide strip (5) and the clips (6)	Clean sealing surfaces. Ensure that all the guides are seated correctly.
5	Install in the reverse order
6	Perform function check of left rear lamp unit (E3) or right rear lamp unit (E4)