Remove/install rear wall between interior and trunk - AR64.20-P-1090V

MODEL 171, 172 

Shown on model 171 

Fig 1: Identifying Rear Wall Interior And Trunk Remove/Install Components - Shown On Model 171

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
	General information on body repair		AH60.00-N-0001-01A
	General information on MB materials		AH98.00-P-9409-03A
1	Remove detachable parts in area to be repaired
2	Unscrew bolts (4) and remove consoles (2)	Model 171	*BA68.74-P-1003-01A
		Model 172	*BA68.74-P-1002-01C
3	Remove seam sealing	Supplement standard seals with sealant.
		Model 171	AR97.10-P-4000V
		Model 172	AR97.10-P-4000W
4	Unscrew bolts (3) from rear wall (1)	Only use M6 X 12 original screws. Otherwise the tank can be damaged.
		Model 171	*BA68.74-P-1002-01A
		Model 172	*BA68.74-P-1001-01C
	Notes on installing rear wall between passenger compartment and trunk		AH64.20-P-1060-01V
5	Unscrew bolts (5) and remove rear wall (1)	Model 171	*BA68.74-P-1004-01A
		Model 172	*BA68.74-P-1003-01C
6	Install in the reverse order

PARTITION WALL

Number	Designation		Model 171
BA68.74-P-1002-01A	Bolt, rear wall between inner compartment and trunk	Nm	8 (± 2)
BA68.74-P-1003-01A	Bolt, console to rear wall mount	Nm	8 (± 2)
BA68.74-P-1004-01A	Bolt, rear wall to upper crossmember	Nm	6

PARTITION WALL

Number	Designation			Model 172
BA68.74-P-1001-01C	Bolt, rear wall between inner compartment and trunk		Nm	8
BA68.74-P-1002-01C	Bolt, console to rear wall mount	M6	Nm	8
		M8	Nm	20
BA68.74-P-1003-01C	Bolt, rear wall to upper crossmember		Nm	6