Remove/install front door lining - AR72.10-P-1000RK

MODEL 231 

Fig 1: Front Door Lining Remove/Install Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Front Door Lining Remove/Install Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of injury  caused by fingers being pinched or crushed  when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof	Keep body components and limbs well clear of moving components.	AS00.00-Z-0011-01A
1	Completely move down crank window
2	Unclip cover (1) with extraction hook	Pulling hook	Fig 4
3	Unclip trim strip (2) starting from rear	Assembly wedge	Figure
4	Unclip airbag badge (3)	Assembly wedge	Figure
5	Remove bolts (4)
6	Unclip door lining (5) on mounting clips (6) from front door	Move assembly wedge directly to mounting clips (6) and ensure that the retaining tabs on the mounting clips (6) do not tear out of the door lining (5). Assembly wedge	Figure
7	Horizontally loosen door lining (5) to side from front door. Guide lock button (7) out of door lining (5).	Loosen door lining (5) from front door until electrical connectors on left door control unit (N69/1) or right door control unit (N69/2), speaker electrical connector (9), inside door opener Bowden cable (10) and tweeter electrical connector (8) are accessible. Ensure that door lining (5) is seated correctly in inner sealing frame.
8	Disconnect electrical connectors from left door control unit (N69/1) or right door control unit (N69/2) Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
9	Disconnect electrical connector on tweeter (8)
10	Disconnect electrical connector on speaker (9)
11	Unhook inside door opener Bowden cable (10) from inner door handle (11).
12	Remove door lining (5)
13	Install in the reverse order

Fig 3: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying Extraction Hook (140 589 02 33 00)

Courtesy of MERCEDES-BENZ USA