Remove/install pressure transducer for boost pressure control - AR07.17-P-7002RKC
ENGINE 279 in MODEL 231
| Remove/install | |||
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | ||
| 1 | Open engine hood | ||
| 2 | Remove engine cover (1) | ||
| 3 | Unclip boost pressure control pressure transducer (Y77/1) from bracket (2) | ||
| 4 | Disconnect electrical connection (3) at boost pressure control pressure transducer (Y77/1) | ||
| 5 | Detach vacuum lines (4) from boost pressure control pressure transducer (Y77/1) | ||
| 6 | Detach vacuum lines (5) from boost pressure control pressure transducer (Y77/1) | ||
| 7 | Install in the reverse order | ||
| 8 | Read out fault memory using diagnostic system and clear if necessary | ||
| AD00.00-P-2000-04A |