Remove/install bass module speaker - AR82.62-P-7839LF

MODEL 222 

with CODE 811 (Advanced sound system) 

Fig 1: Bass Module Speaker Remove/Install Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Bass Module Speaker Remove/Install Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Notes on sensor system for trunk lid opening/closing		AH80.61-P-0001-01A
	Remove/install
1	Switch off ignition and remove transmitter key from electronic ignition lock control unit
2	Remove panels at left in trunk	MODEL 222.0/1 with CODE 811 (Advanced sound system)	AR68.30-P-4600LF
3	Open latch (2)
4	Remove screws/bolts (1) and remove bass box together with rear bass speaker (H4/38) until electrical connectors (3) are accessible	Bolt, woofer to bracket	*BA82.62-P-1002-04B
5	Disconnect electrical connectors (3) and remove bass box together with rear bass speaker (H4/38) from vehicle
6	Transfer bass speaker amplifier (N40/9)	Only when replacing rear bass speaker (H4/38).
7	Install in the reverse order
8	Perform function test

SPEAKER

Number	Designation			Model 222
BA82.62-P-1002-04B	Bolt, woofer to bracket	M6x12	Nm	6