Remove/install panic alarm system control unit (GAS) - AR82.25-P-1206LFS
MODEL 222.1
with CODE Z07 (Top protection)
with CODE Z22 (Panic alarm system)
Shown on vehicle with CODE Z21 (Fire extinguishing system)
Fig 1: Panic Alarm System Control Unit (Gas) Remove/Install Components - Shown On Vehicle With Code Z21
| Remove/install | |||
| 1 | Switch off ignition, detach transmitter key from electronic ignition switch control unit | ||
| 2 | Remove fire extinguisher agent reservoir | MODEL 222.1 with CODE Z07 (Top protection) with CODE Z21 (Fire extinguishing system) with CODE Z22 (Panic alarm system) |
AR86.10-P-0100LFS |
| 3 | Remove trunk floor paneling and equipment carrier plate | MODEL 222.1 with CODE Z07 (Top protection) with CODE Z22 (Panic alarm system) with CODE Z25 (Emergency fresh air system with equipment carrier plate) |
AR68.30-P-4600LF |
| 4 | Unscrew nuts (1) and lay cover (2) down to side | ||
| 5 | Disconnect electrical connectors (4) from PAS [GAS] and special signal system control unit (N26/12) | ||
| 6 | Unscrew nuts (3) and remove PAS [GAS] and special signal system control unit (N26/12) | ||
| 7 | Install in the reverse order |