Remove/install inside rearview mirror - AR68.40-P-0001LF

MODEL 222.0/1/9 

Shown on vehicle with CODE 338 (Mirror travel distance recorder) 

Fig 1: Inside Rearview Mirror Remove/Install Components

Courtesy of MERCEDES-BENZ USA

Fig 2: Inside Rearview Mirror Remove/Install Components - Shown On Vehicle With Code 338 (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 3: Inside Rearview Mirror Remove/Install Components - Shown On Vehicle With Code 338 (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by irritation of the skin, eyes and respiratory system through contact or inhalation of substances contained in the mirror lens.	Wear protective gloves and safety glasses.	AS60.00-Z-0008-01R
	Remove/install
1	Remove overhead control panel control unit		AR82.20-P-1000LF
2	Unclip rain/light sensor cover (1) in direction of arrow and remove
3	Unclip mirror base cover (2) and remove
4	Remove cable tie (7) from mounting point (arrow A)	MODEL 222.0/1 with CODE 338 (Mirror odometer) Slightly tension taximeter cable (61) and microphone cable (51) from inside rearview mirror (A67) to mounting point (arrows A) and tighten cable tie.
5	Unhook taximeter cable (61) from retaining tab (8)	MODEL 222.0/1 with CODE 338 (Mirror odometer)
6	Unhook microphone cable (51) from retaining tab (8)
7	Disconnect electrical connection (5)
8	Disconnect electrical connector (6)	MODEL 222.0/1 with CODE 338 (Mirror odometer)
9	Turn inside rearview mirror (A673) on mirror base (4) to right with open end wrench and remove from mirror holder
10	Adjust inside rearview mirror to national version	When replacing inside rearview mirror (A67).	AR68.40-P-0001-01A
11	Install in the reverse order