Remove/install radiator - AR20.20-P-3865LF
MODEL 217 with ENGINE 157, 276.8, 278
MODEL 222 with ENGINE 157, 276.8/9, 278, 642, 651
Shown on vehicle with engine 278
Shown on vehicle with ENGINE 651
| Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury to skin and eyes suffering scalding from contact with hot coolant spray. Risk of poisoning from swallowing coolant. | Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. Wear protective gloves, protective clothing and safety glasses. |
AS20.00-Z-0001-01A | |
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Remove/install | |||
| 1 | Remove front right cover above coolant expansion reservoir | ||
| 2 | Remove fan | Model 222 with engine 651 | AR20.40-P-5050OLF |
| Model 217 with engine 157, 276, 278 Model 222 with engine 157, 276.8/9, 278, 642 |
AR20.40-P-5050LF | ||
| 3 | Remove coolant hose (8) | AR20.20-P-7441-01RQ | |
| 4 | Detach coolant hose (6) at radiator (2) | AR20.20-P-7441-01RQ | |
| 5 | Detach coolant hose (1) at radiator (2) | AR20.20-P-7441-01RQ | |
| 6 | Detach coolant hose (7) at radiator (2) | AR20.20-P-7441-01RQ | |
| 7 | Remove coolant line cooler (2) below | ||
| 8 | Unclip the bracket of the oil line below on the cooler (2) | Model 217 with engine 278 Model 222 with engine 278 |
|
| 9 | Remove front center reinforcement | AR62.30-P-1570LF | |
| 10.1 | Unfasten air duct segment (9) at radiator (2) and place to one side | Model 217 with engine 157, 278 Model 222 with engine 157, 278 |
|
| 10.2 | Remove air duct segment (10) | Model 222 with engine 642, 651 | |
| 11 | Remove screws/bolts (11) | Model 217 with engine 157, 278 Model 222 with engine 157, 278, 651 |
|
| 12 | Unclip radiator (2) from left supporting frame (3) and detach supporting frame on the right and remove downwards | In doing so press oil cooler for A/T to the side. The cooler (2) will be damaged otherwise. |
|
| 13 | Install in the reverse order |