Remove/install charger feed socket flap - AR54.10-P-5110LFH

MODEL 222.163 

Fig 1: Charger Feed Socket Flap Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Risk of death  when touching components on vehicles with high-voltage on-board electrical system	Do not touch components and open lines of the high-voltage on-board electrical system. Persons who wear electronic implants (e.g. cardiac pacemakers), must not  carry out any work on high-voltage on-board electrical systems.	AS54.00-Z-0001-01A
	Note on the high-voltage on-board electrical system		AH54.00-P-0010-01A
	Evaluation of high-voltage components		AH54.00-P-6500-01SXH
	Remove
1	Switch off ignition and remove transmitter key
2.1	Unplug charger cable plug from charger feed socket	If charger cable plug is plugged in
2.2	Open socket flap (1) in the rear bumper	If charger cable plug is not plugged in After activating the high voltage on-board electrical system, the socket flap (1) can no longer be opened!
3	Open the charger feed socket flap (2)	If charger cable plug is not plugged in
4	Remove the charger feed socket flap (2)	Release catches (arrows) on the retaining ring (3) using a small screwdriver and remove the retaining ring (3) with the charger feed socket flap (2).
	Install
5	Install the charger feed socket flap (2)	Position the retaining ring (3) with the charger feed socket flap (2) on the charger feed socket and press it down until the catches (arrows) engage.
6	Close the charger feed socket flap (2)
7	Close socket flap (1) in the rear bumper