Remove/Install Special Tool For Roof Support - AR77.00-S-1000E
Model 447.7/8
With Code ZK9 (Lifting roof hatch)
Model 447.8
With Code ZK0 (EASY UP pop-up roof, electric)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notice | Notes on carrying out repair work in the vehicle interior | AH68.00-D-0001-01KOS | |
| Remove | |||
| 1 | Remove upper paneling from pop-up roof cutout | AR77.70-S-0020E | |
| Installing | |||
| 2 | Insert bottom section (4) of locating tool in center of front roof cutout (5) | Fig 1 | |
| 3 | Turn top section (1) of locating tool upward until stamp (2) on pop-up roof frame (3) makes contact and the pop-up roof is supported | ||
| Remove | |||
| 4 | Turn top section (1) of locating tool downward and remove locating tool | ||
| Install | |||
| 5 | Install front paneling on pop-up roof cutout | AR77.70-S-0020E |