Remove/Install License Plate Lamp Bracket - AR72.20-S-1010E
Model 447.6/7
With Code W50 (Rear-end door, double-wing, 180 degrees without window)
Model 447.6/7
With Code W54 (Hinged rear doors, opening to side wall)
Shown On Model 447.6 With Code FR8 (Reversing camera)
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Remove/install | |||
| 1 | Detach door foil (2) on left rear-end door (3) until nuts (4) are accessible | AR72.20-S-4100E | |
| 2 | Separate electrical connections (6) | MODEL 447.6/7 with CODE FR8 (Rear view camera) with CODE W50 (Rear-end door, double-wing, 180 degrees without window) MODEL 447.6/7 with CODE FR8 (Rear view camera) with CODE W54 (Hinged rear doors, opening to side wall) |
|
| 3 | Unscrew nuts (4) | ||
| 4 | Unclip license plate bracket (1) and guide to side until electrical connectors are accessible (5) | Fig 1 | |
| 5 | Unclip left rear-end door license plate lamp (E19/3) and right rear-end door license plate lamp (E19/4) and disconnect electrical connectors (5) | ||
| 6 | Unclip reversing camera (7) from license plate lamp bracket (1) | MODEL 447.6/7 with CODE FR8 (Rear view camera) with CODE W50 (Rear-end door, double-wing, 180 degrees without window) MODEL 447.6/7 with CODE FR8 (Rear view camera) with CODE W54 (Hinged rear doors, opening to side wall) |
|
| 7 | Install in the reverse order | ||
| Check | |||
| 8 | Check function of left rear-end door license plate lamp (E19/3) and right rear-end door license plate lamp (E19/4) | ||
| 9 | Check reversing camera (7) for proper function | MODEL 447.6/7 with CODE FR8 (Rear view camera) with CODE W50 (Rear-end door, double-wing, 180 degrees without window) MODEL 447.6/7 with CODE FR8 (Rear view camera) with CODE W54 (Hinged rear doors, opening to side wall) |