Preparing New Rear Fender - AR63.50-P-1400-03GQ

MODEL 166.0 except CODE Z04 (Light armoring) 

1. Scribe separating points on rear fender (1) and cut (areas X₁ and X₂ ).

   Transfer dimensions from vehicle.

2. Remove section from rear fender (1).
3. Grind mating surfaces on rear fender (1) down to bare metal in crosshatched areas.

   Sand down spot weld flanges to bare metal on both sides.

4. Coat insides of spot welding flange on rear fender (1) with zinc dust paint.