Install And Weld In Outer Part Of Rear Center Section - AR64.20-P-1000-10GQS

MODEL 166.0 with CODE Z04 (Light armoring) 

000 588 02 84 00 Welder

WS60.00-P-0022K

Courtesy of MERCEDES-BENZ USA

1. Install center part of inner rear center section (1) and outer rear center section, taillamps and seal and fit.
2. Check gap dimensions and adjust with feeler gauge.
3. Fix center part of rear inner rear center section (1) with clamping pliers.
4. Remove taillamp and seal.
5. Center part of inner rear center section (1) (areas E₁ and E₂ ).
6. Inner rear center section (1) (area L).
7. Install center rear center section (2), fit and fix in place.
8. Center rear center section (2) (areas M₁ , M₂ and M₃ ).
9. Outer rear center section (3) (areas O, Q)
10. Outer rear center section (3) (areas N, P, R₁ , R₂ )