LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2016 >> GLE550 >> Repair and Diagnosis >> General Information >> OEM General Information >> Overall Vehicle - 166 Chassis - 4 Of 9 >> Testing & Repair >> Perform Basic Programming - AR00.19-P-0200GZ

Perform Basic Programming - AR00.19-P-0200GZ

MODEL 164, 166 

  Adjust    
1 Close all doors    
2 Switch on ignition    
3 Set time on instrument cluster    
4 Switch low beam on and off    
5 Switch radio on and off    
6 Lower all power windows all the way down    
7 Raise all power windows all the way up and in this position, press and hold the respective switch of the power window switch group for at least 3 s    
8 Open sliding roof all the way, close it again and press and hold switch, after closing, for at least 3 s to normalize the glass sliding roof Model 164, 166
with code 414 (Sliding sunroof)
Model 166
with code 413 (Automatic panoramic sliding sunroof)
 
9 Operate express function by briefly pressing the switch beyond point of resistance Model 164, 166
with code 414 (Sliding sunroof)
Model 166 with code 413 (Automatic panoramic sliding sunroof)
IMPORTANT If the sliding roof is thereby fully opened, the normalization was successful.
 
10 Repeat operation steps 8 and 9 Model 164, 166
with code 414 (Sliding sunroof)
Model 166
with code 413 (Automatic panoramic sliding sunroof)
If sliding roof was not fully opened by the express-function.
 
11 Normalize power pop-out windows Model 164, 166 with code 848 (Power side vent windows)  
12 Start engine    
13 Switch air conditioning on and off    
14 Switch rear air conditioning on and off Model 164, 166 with code 582 (Rear air conditioner)  
15 Turn steering wheel to left stop, then turn it to right stop IMPORTANT To normalize the steering angle sensors.  
16 Switch off engine and ignition and remove transmitter key    
17 Get out of the vehicle and close driver door    
18 Lock and unlock vehicle    
19 Open and close driver door    
20 Switch on ignition Model 164 with code 245 (Electronic compass)  
21 Call up and run calibration via instrument cluster Model 164 with code 245 (Electronic compass)  
22 Start engine Model 164 with code 245 (Electronic compass)  
23 Switch off all electrical consumers in the vehicle that are not required Model 164 with code 245 (Electronic compass)  
24 Drive a full circle at low speed Model 164
with code 245 (Electronic compass)
IMPORTANT To calibrate the compass.