Remove/Install Rear Axle Headlamp Range Adjustment Sensor - AR82.10-P-4084GQ

MODEL 166 

as of model year 2016 

with CODE 610 (Night view assist) 

MODEL 166 

as of model year 2016 

with CODE 641 (Headlamps, LED, dynamic, left-side traffic) 

MODEL 166 

as of model year 2016 

with CODE 642 (Headlamps, LED, dynamic, right-side traffic) 

MODEL 166 

with CODE 615 (Bi-xenon headlamps with active light function) 

MODEL 166 

with CODE 621 (Bi-xenon adapt. headl., left-s. traffic) 

MODEL 166 

with CODE 622 (Intelligent Light System) 

MODEL 292 

Shown on model 166 

	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Lift vehicle on vehicle lift		AR00.60-P-1000GZ
2	Unclip lever (2)
3	Remove bolts (3)	Bolt, level sensor to retaining plate	*BA82.10-P-1001-02C
4	Remove left rear level sensor (B22/7) or right rear level sensor (B22/10) from retaining plate
5	Disconnect electrical connector from left rear level sensor (B22/7) or right rear level sensor (B22/10)
6	Install in the reverse order
	Initial startup
7	Connect diagnostic system, read out fault memory and adjust zero position of headlamps
			AD00.00-P-2000-04A
8	Check headlamp setting and correct if necessary
		Model 166 as of model year 2016 with code 610 (Night view assist) Model 166 as of model year 2016 with code 641 (Headlamps, LED, dynamic, left-side traffic) Model 166 as of model year 2016 with code 642 (Headlamps, LED, dynamic, right-side traffic) Model 166 with code 615 (Bi-xenon headlamps with active light function) Model 166 with code 621 (Bi-xenon adapt. headl., left-s. traffic) Model 166 with code 622 (Intelligent Light System)	AP82.10-P-8260GZA
		Model 292	AP82.10-P-8260I

Number	Designation		Model 166	Model 292
BA82.10-P-1001-02C	Bolt, level sensor to retaining plate	Nm	5	5