Repair Squib Wiring Harness For Supplemental Restraint System (SRS) - AR54.18-P-0600A
MODEL 117, 124, 126, 129, 140, 156, 163, 164, 166, 168, 169, 170, 171, 172, 176, 190, 197, 202, 203, 204, 205, 207, 208, 209, 210, 211, 212, 213, 215, 216, 217, 218, 219, 220, 221, 222, 230, 231, 240, 242, 245, 246, 251, 253, 257, 292, 414, 415, 447, 448, 461 as of 4/1/94, 463, 470, 471
| Risk of injury during testing and repair operations related to pyrotechnical components | Do not expose pyrotechnical components to temperatures above 100 °C or 212 °F. Disconnect current supply when working on such components. |
AS91.00-Z-0008-01A | |
| Notes on replacement of safety-relevant and special components | AH00.19-P-1000-08A | ||
| Information, assessment and legal requirements when working with, handling and storing pyrotechnical components | AH91.00-Z-0000-10A | ||
| Notes on cable protection | AH00.19-P-1000-11A | ||
| Remove | |||
| 1 | Remove detachable parts in repair area | ||
| Repair wiring harness | |||
| 2 | Determine and mark positive line (Pin 1 on connector plug of squib) | ||
| 3 | Repair wiring harness using end sleeves | AR00.19-P-0100-09A | |
| 000 588 00 84 00 Heat gun | WS54.00-P-0049B | ||
| Fig 5 | |||
| Fig 3 | |||
| Fig 7 | |||
| Fig 8 | |||
| Fig 4 | |||
| Fig 1 | |||
| 4 | Protect repair point after performing line repair | AR00.19-P-0100-08A | |
| 000 588 00 84 00 Heat gun | WS54.00-P-0049B | ||
| Check | |||
| 5 | Check wiring harness | AR54.18-P-0600-01A | |
| Fig 2 | |||
| Fig 6 | |||
| Install | |||
| 6 | Install removed detachable parts in repair area |