Retrofit Adaptive Highbeam Assist Plus - AN82.10-P-0011GQC

MODEL 292.### 1# with CODE 238 (Active lane keeping Assist) with code 642 (Headlamps, LED, dynamic, right-side traffic) 

MODEL 292.### 1# with CODE 476 (Lane keeping assist) with code 642 (Headlamps, LED, dynamic, right-side traffic) 

MODEL 292.### 1# with CODE 513 (Speed Limit Assist) with code 642 (Headlamps, LED, dynamic, right-side traffic) 

MODEL 292.### 2# with CODE 238 (Active lane keeping Assist) with code 641 (Headlamps, LED, dynamic, left-side traffic) 

MODEL 292.### 2# with CODE 476 (Lane keeping assist) with code 641 (Headlamps, LED, dynamic, left-side traffic) 

MODEL 292.### 2# with CODE 513 (Speed Limit Assist) with code 641 (Headlamps, LED, dynamic, left-side traffic) 

	Initial startup
1	Order retrofitting via parts ordering process, specifying vehicle identification number (FIN)	Further Information available in the Aftersales Portal at: Info-Center → PIT Aftersales → Parts → Genuine parts → Cars
	Update Vehicle Documentation (VeDoc)
2	Enter special equipment into the online vehicle data card	Code 628 (Adaptive Highbeam Assist Plus)
3	Attach note Adaptive Highbeam Assist retrofitted as per AN82.10-P-0011GQC under field organization texts to design group 54 and design group 82
4	Connect diagnostic system and select vehicle using FIN
			AD00.00-P-2000-04A
5	Carry out variant coding using software calibration number (SCN)	Central gateway (CGW) Signal acquisition and actuation module (SAM) Multifunction camera (MFK) Instrument cluster (KI) Headlamp (SW) Chassis gateway (FWGW)
6	Disconnect diagnostic system
			AD00.00-P-2000-04A
	Check
7	Perform function test	See owner's manual.