Install Rear Crossmember - AR64.20-P-1100-05GQ

MODEL 166, 292 

Shown on model 166.0 

1. Install rear crossmember (1) with rear center section and fit.
2. Check and adjust gap dimensions.
3. Fix rear crossmember (1) in place.
4. Remove rear center section.
5. Drill Ø 6.7 mm rivet holes in rear crossmember (1) (areas E₁ and E₂ ).
6. Remove rear crossmember (1).
7. Deburr rivet holes on both sides.
8. Coat insides of riveted joints with zinc dust paint.
9. Rivet rear crossmember (1) with Ø 6.4 x 14 blind rivet (areas E₁ and E₂ ).
10. Rear crossmember (1) (areas F₁ , F₂ and G).