Remove/Install Camber Strut - AR35.20-P-0110LWX

Model 253.388/389/988/989 

Courtesy of MERCEDES-BENZ USA

Shown on left side of vehicles 

	Notes on threaded connections fastened using a tightening angle-based tightening process		AH00.00-P-0020-01A
	Notes on handling, transport and storage of ceramic brake disks		AH42.10-P-9406-13A
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
	Notes on handling, transport and storage of composite brake disks		AH42.10-P-9406-12LF
	Notes on repair work on suspension components		AH00.00-P-0100-01A
	Remove
1	Remove rear axle		AR35.10-P-0010LWX
2	Detach camber strut (1) from wheel carrier (2)	The screwdriver bit is to be used when a bolt with a multi-socket tooth profile is fitted
		Screwdriver bit	Fig 1
3	Detach camber strut (1) from rear axle carrier (3) and remove	The screwdriver bit is to be used when a bolt with a multi-socket tooth profile is fitted
		Screwdriver bit	Fig 1
	Check
4	Check camber strut (1) for condition and damage	When reinstalling camber strut (1). If there are problems ↓ Replace camber strut (1).
5	Check elastomer bearing of camber strut (1) on wheel carrier (2) for condition and damage	If there are problems ↓ Replace elastomer bearing.
			AR35.20-P-3404LWX
	Install
6	Attach camber strut (1) to rear axle carrier (3)	The screwdriver bit is to be used when a bolt with a multi-socket tooth profile is fitted.
		Bolt, camber strut to rear axle carrier	*BA35.20-P-1001-02L
		Screwdriver bit	Fig 1
7	Attach camber strut (1) to wheel carrier (2)	The screwdriver bit is to be used when a bolt with a multi-socket tooth profile is fitted.
		Bolt, camber strut to wheel carrier	*BA35.20-P-1002-02L
		Screwdriver bit	Fig 1
8	Install rear axle		AR35.10-P-0010LWX

Fig 1: Identifying Screwdriver Bit (119 589 00 10 00)

Courtesy of MERCEDES-BENZ USA