Remove/Install Cigarette Lighter - AR54.10-P-0030LW

Model 205, 213, 238, 253, 293 

with code 301 (Package SMOKER) 

Shown on model 205 

Fig 1: Front Cigarette Lighter Components Location - Model 253 With Code 301 (Shown On Model 205)

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Switch off ignition and store transmitter key outside of transmission range (min. 2 m).
2	Open flap (7).
3	Pull insert (1) out of housing (3).
4	Release housing (3) using pliers (2) and pull out of clamping sleeve (4) far enough to gain access to the electrical connector (5).	The studs of the special tool pliers (2) must engage in the cutouts of the housing (3) (arrows A).
		Pliers	Fig 2
5	Disconnect electrical connector (5) and remove housing (3).
6	Unclip spring pin (4) from stowage compartment with ashtray (6) by pushing back the two catch hooks, and then remove it.	Check for correct installation position of spring pin (4).
7	Install in the reverse order.

Fig 2: Identifying Pliers (169 589 00 37 00)

Courtesy of MERCEDES-BENZ USA