Remove/install rear door lining - AR72.12-P-1010GQ
MODEL 166 except CODE (Z04) Light armoring except CODE (Z05)
Illustrated on model 166.004
| Remove/install | |||
| Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof | Keep body parts and limbs well clear of moving parts. | AS00.00-Z-0011-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1 | Switch off ignition and remove the transmitter key from the EIS [EZS] control unit | ||
| 2 | Remove left rear door tweeter (H4/35) or right rear door tweeter (H4/36) | Figure | |
| 3 | Unclip cover (1) | Figure | |
| 4 | Remove bolts (2) | ||
| 5 | Unclip door lining (3) from mounting clips (arrows) on rear door (4) | ||
| Figure | |||
| 6 | Horizontally loosen door lining (3) to side from rear door (4). Guide lock button (5) out of door lining (3) | Installation Ensure that door lining (3) is seated correctly in inner sealing frame. |
|
| 7 | Disconnect electrical connectors (6) from left rear door control unit (N69/3) and right rear door control unit (N69/4) | ||
| 8 | Unhook inside door opener Bowden cable (7) from inner door handle (8) | ||
| 9 | Remove door lining (3) | ||
| 10 | Install in the reverse order |