Remove/Install Backup Camera - AR54.65-P-0030GQ
MODEL 166 with CODE 218 (Reversing camera)
MODEL 166 with CODE 501 (360 degree camera)
Shown with CODE 218 (Reversing camera) up to model year 2014
Shown with CODE 501 (360 degree camera)
| Remove/install | |||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1.1 | Switch off ignition and remove transmitter key from electronic ignition lock control unit | MODEL 166 with CODE 218 (Reversing camera) without CODE 889 (KEYLESS-GO) MODEL 166 with CODE 501 (360 degree camera) without CODE 889 (KEYLESS-GO) |
|
| 1.2 | Detach KEYLESS GO start-stop button from electronic ignition lock control unit | MODEL 166 with CODE 218 (Reversing camera) with CODE 889 (KEYLESS-GO) MODEL 166 with CODE 501 (360 degree camera) with CODE 889 (KEYLESS-GO) |
|
| 2 | Remove lower and center door lining from tailgate | AR72.20-P-3520GQ | |
| 3 | Dismantle, release and detach electrical connections (1) for reversing camera (B84/3) or rear 360° camera (B84/10) from rear-end door | ||
| 4 | Release and disconnect electrical connections (3) of reversing camera (B84/3) from rear-end door | MODEL 166 with CODE 218 (Reversing camera) |
|
| 5 | Remove bolt (2a) | MODEL 166.0 up to model year 2014 with CODE 218 (Reversing camera) |
|
| 6 | Remove clamp (2) | ||
| 7 | Remove reversing camera (B84/3) or rear 360° camera (B84/10) from door handle | ||
| 8 | Install in the reverse order | ||
| 9.1 | Calibrate reversing camera (B84/3) using STAR DIAGNOSIS and calibration device | MODEL 166 with CODE 218 (Reversing camera) During initial startup or after working on the reversing camera (B84/3) or rear-end door |
|
| AD00.00-P-2000-04A | |||
| Fig 3 | |||
| 9.2 | Calibrate rear 360° camera (B84/10) using STAR DIAGNOSIS | MODEL 166 with CODE 501 (360 degree camera) At the in-service date or after working on the rear 360° camera (B84/10) or rear-end door |
|
| AD00.00-P-2000-04A |