Remove/install radiator - AR20.20-P-3865MLJ
MODEL 166 with ENGINE 157
MODEL 166 with ENGINE 278
MODIFICATION NOTES
| 19.4.12 | Value changed: Nut/bolt, high-pressure line to accumulator | *BA83.30-P-1001-01J | |
| 24.5.12 | Mother / screw high-pressure line to Flussigkeitsbehalter | TYP 166 | *BA83.30-P-1001-01J |
Shown on model 166
| Remove/install | |||
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by vehicle manufacturer. | AS00.00-Z-0010-01A | |
| 1 | Remove engine intake air ducts (1) upstream of air filter | ||
| 2 | Remove cold air intake (11) | ||
| 3 | Drain air conditioning system | AR83.30-P-1760CW | |
| 4 | Remove fan unit (12) | AR20.40-P-5050MLJ | |
| 5 | Remove bottom engine compartment paneling | AR61.30-P-1001GQ | |
| 6 | Drain coolant at radiator (6) | AR20.00-P-1142GQ | |
| Notes on coolant | AH20.00-N-2080-01A | ||
| 7 | Detach coolant hoses (3, 8) from radiator (6) | AR09.41-P-1311-01AL | |
| 8 | Disconnect coolant line (9) | ||
| 9 | Loosen circulation pump holder (10) | Engine 157 | |
| 10 | Do not disconnect refrigerant lines (2, 5) at radiator (6) | *BA83.30-P-1001-01J | |
| 11 | Disconnect transmission fluid lines (7) at radiator (6) | ||
| 12 | Remove air ducting on the left and right (4) for engine mount | ||
| 13 | Take out radiator (6) with the aid of another person in an upward direction | ||
| Check | |||
| 14 | Check radiator (6) for signs of damage | Only when reusing the radiator (6) ↓ Install new radiator (6) if necessary. |
|
| 15 | Install in the reverse order | ||
| 16 | Inspect cooling system for leaks | AR20.00-P-1010GQ | |
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 17 | Perform engine test run and check cooling system for proper operation |
AIR CONDITIONING
| Number | Designation | MODEL 166 | |
|---|---|---|---|
| *BA83.30-P-1001-01J | Nut/bolt, high-pressure line to fluid reservoir | Nm | 7 |