Remove/install cooling line of power steering system - AR46.25-P-3010GW
MODEL 463 (except 463.322/323) as of model year 2013
Illustration shows engine 157
Shown on engine 176
| Risk of injury to skin or eyes from hydraulic fluid spraying out under pressure. Risk of poisoning from swallowing hydraulic fluid. | Depressurize hydraulic system completely before starting any work on it. Wear protective clothing and safety glasses. | AS00.00-Z-0013-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove | |||
| 1 | Remove radiator grille | AR88.00-P-2115GW | |
| 2 | Remove left headlamp unit | AR82.10-P-4730GW | |
| 3 | Remove left front wheel well lining | Model 463 (except 463.322/323) as of model year 2013 up to model year 2015 | |
| 4 | Extract hydraulic fluid from power steering expansion reservoir | ||
| Figure | |||
| 5 | Thoroughly clean the area surrounding the hydraulic system for the power steering at the connecting points | Before opening the power steering's hydraulic system the area around the separation point should be cleaned thoroughly. Even minute particles of dirt, introduced into the hydraulic components, can result in malfunctions or damage to the power steering. |
|
| 6 | Detach hydraulic hose (1, 3) from coolant line (2) of power steering | ||
| 7 | Collect escaping hydraulic fluid in suitable container | ||
| 8 | Seal exposed connections with plugs | Figure | |
| 9 | Detach left horn | Model 463 (except 463.322/323) as of model year 2013 up to model year 2015 | |
| 10 | Detach bracket (6) | Model 463 (except 463.322/323) as of model year 2016 | |
| 11.1 | Unscrew nuts (4) | Model 463 (except 463.322/323) as of model year 2013 up to model year 2015 | |
| 11.2 | Remove bolts (5) | Model 463 (except 463.322/323) as of model year 2016 | |
| 12 | Remove coolant line (2) | ||
| Install | |||
| 13 | Install coolant line (2) | ||
| 14.1 | Tighten nuts (4) | Model 463 (except 463.322/323) as of model year 2013 up to model year 2015 | |
| 14.2 | Screw bolts (5) tight | Model 463 (except 463.322/323) as of model year 2016 | |
| 15 | Mount bracket (6) | Model 463 (except 463.322/323) as of model year 2016 | |
| 16 | Mount left horn | Model 463 (except 463.322/323) as of model year 2013 up to model year 2015 | |
| 17 | Remove stop plugs and fit hydraulic hoses (1, 3) to coolant line (2) | ||
| 18 | Add hydraulic fluid to power steering expansion reservoir | AR46.20-P-0500-10F | |
| 19 | Check connections of installed hoses for leaks | ||
| 20 | Install left front wheel well lining | Model 463 (except 463.322/323) as of model year 2013 up to model year 2015 | |
| 21 | Install left headlamp unit | AR82.10-P-4730GW | |
| 22 | Install radiator trim | AR88.00-P-2115GW |