Remove/install pop-up bracket on tilting/sliding roof - AR77.20-P-1700GW

MODEL 463 (except 463.202) as of model year 2013/model refinement package 2012 

Fig 1: Tilting/Sliding Roof Pop-Up Bracket Remove/Install Components (1 Of 6)

Courtesy of MERCEDES-BENZ USA

Fig 2: Tilting/Sliding Roof Pop-Up Bracket Remove/Install Components (2 Of 6)

Courtesy of MERCEDES-BENZ USA

Fig 3: Tilting/Sliding Roof Pop-Up Bracket Remove/Install Components (3 Of 6)

Courtesy of MERCEDES-BENZ USA

Fig 4: Tilting/Sliding Roof Pop-Up Bracket Remove/Install Components (4 Of 6)

Courtesy of MERCEDES-BENZ USA

Fig 5: Tilting/Sliding Roof Pop-Up Bracket Remove/Install Components (5 Of 6)

Courtesy of MERCEDES-BENZ USA

Fig 6: Tilting/Sliding Roof Pop-Up Bracket Remove/Install Components (6 Of 6)

Courtesy of MERCEDES-BENZ USA

	Removing
1	Remove paneling from tilting/sliding roof		AR77.20-P-0500GW
2	Remove tilting/sliding roof panel		AR77.20-P-1000GW
3	Remove guide plate (1) from sliding carrier (2)
4	Remove mounting bracket from tilting/sliding roof panel (4)	Remove upward out of side guide (gate).
5	Remove water drain runnel		AR77.20-P-1999GW
6	Remove sliding carrier (2)
7	Remove lifting bracket (5)	Slide lifting bracket (5) to stop toward front, tilt upward and remove toward inside at an angle.
	Install
8	Grease lifting bracket (5) on slide shoes (7) and moving parts		*BR00.45-Z-1004-06A
9	Install lifting bracket (5)	Ensure that slide shoes (7) are seated properly. Otherwise malfunctions can occur.
10	Install sliding carrier (2)	Press lifting bracket (5) slightly outwards with screwdriver, then tighten bolts on sliding carrier (2).
11	Install water drain runnel		AR77.20-P-1999GW
12	Adjust basic position on lifting bracket mechanism	Insert left and right adjustment gauges (6) into side guide (gate) and into groove in lifting bracket (5) (arrows). Do not remove adjustment gauges (6) until tilting/sliding roof panel is installed.
			Fig 7
			Fig 8
13	Install mounting bracket for tilting/sliding roof panel (4)
14	Install guide plate (1) on sliding carrier (2)
15	Install tilting/sliding roof panel		AR77.20-P-1000GW
16	Remove adjustment gauges (6) on left and right		Fig 7
			Fig 8
17	Actuate tilting/sliding roof and move to all positions a number of times
18	Close tilting/sliding roof and check markings (8) and marking notches (9) at left and right sliding rail	If the marking (8) is located outside the notches (9) on the sliding rail: ↓
		Remove left paneling from rear pillar: ↓	AR68.30-P-4505GW
		Perform fine adjustment of tilting/sliding roof.	AR77.20-P-1100-02A
19	Carry out function check
20	Install left paneling on tilting/sliding roof		AR77.20-P-0500GW
21	Install paneling on rear pillar	If necessary	AR68.30-P-4505GW

Fig 7: Identifying Adjustment Gauge (124 589 17 21 00)

Courtesy of MERCEDES-BENZ USA

Fig 8: Identifying Adjustment Gauge (124 589 18 21 00)

Courtesy of MERCEDES-BENZ USA