Removing and installing APS radio and navigation control module - AR82.61-P-7412G

MODEL 463 up to 30.11.00 with CODE (EF1) Audio 10 RDS 

MODEL 463 up to 30.11.00 with CODE (EF2) Audio 10 RDS with CD slot 

MODEL 463 up to 30.11.00 with CODE (EF3) Audio 30 RDS 

MODEL 463 up to 30.11.00 with CODE (ET6) Auto pilot system (APS) 

Fig 1: APS Radio And Navigation Control Module Remove/Install Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: APS Radio And Navigation Control Module Remove/Install Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Removing, installing
1	Pull out radio and navigation control module (A2/29)		*WH58.30-Z-1005-19A
		For this purpose slide in removal plates (4) Press retaining springs (arrow) back from removed radio and pull out removal plates (4). Press radio and navigation control module in at points marked with (A) with max. 100 N.
2	Disconnect electrical connectors (to 3) from rear of radio and navigation control module (A2/29)	Do not kink or stretch D2B fiber optic cable (2)
3	Install in the reverse order
4	Encode radio	When replacing radio reactivate unit and enter radio code. When installing the same unit activate only radio code see: ↓
		Encode radio	AR82.60-P-7502-01M
		When replacing radio with navigation control module (code ET6) reconfigurate unit and activate radio code. When installing the same unit activate only radio code See: ↓
		Encode radio	AR82.60-P-7502-01B
		Configurate radio and navigation control module (APS)	AR82.61-P-7412-02G
		After connecting radio and navigation control module voice output is loaded automatically within 20 minutes.