General Information On Vehicle Level Measurement - AR40.00-P-0202XG

Model 463 

as of model year 2019 

	Check
1	Check condition of vehicle.	For the vehicle level check, all vehicle parts must be installed and the vehicle completed and in a ready to drive condition. Do not load the vehicle.
2	Visually inspect tires for wear and damage; visually inspect tire tread.
3	Visually inspect rims for damage.
4	Check and correct tire pressure.
5	Visually inspect vehicle underside for damage, corrosion to suspension, chassis and supporting body panels, and leaks at major assemblies and lines.
6	Raise vehicle at side at jack support point and check wheel bearing play without dial indicator.	Do not raise the vehicle at the axles. Otherwise the axles will be damaged.
7	Check condition of mechanical steering components.		AP46.00-P-4651GA
8	Check front axle joints for play and check seal bellows for damage.		AP33.10-P-3358GA
9	Check rear axle joints for play and check seal bellows for damage.		AP35.20-P-3552GA
10	Check condition of shock absorbers and springs.		AP32.25-P-3255GA
11	Drive vehicle onto measuring station and secure against rolling away.	The vehicle lift must be horizontal at the measuring position.
12	Move vehicle to driving level.