Fill Out Data Sheet - AR40.20-P-0200-15XG

Model 463 

as of model year 2019 

1. Enter customer data.
2. Enter the tire data in the table "1. Tires".
3. Copy the specified vehicle level values from the basic data into table "2. Vehicle level".
4. Measure the actual values for the vehicle level and enter them.
5. Copy the specified toe values from the basic data in table "3. Toe".
6. Measure the actual values for the toe and enter them.
7. Copy the specified camber values for the rear axle from the basic data to table "5. Rear axle camber" in the column Degrees (°)/minutes (').
8. Measure the actual values for the rear axle camber and enter them.
9. Convert the camber values for the rear axle into decimal degrees and enter them into the Decimal degrees (°) column.

   To help with conversion, use table "4. Conversion table, minutes to decimal degrees". Example: -1° 53' =-1.88°.

10. Calculate the difference value in camber at the rear axle and enter it into table "5. Rear axle camber" at position 5.1 and 5.2 Difference in camber (DS).

    The difference value is the difference between the specified value and the actual value in decimal degrees (°). i.e. the actual value must be subtracted from the specified value. 

11. Copy the specified camber values for the front axle from the basic data to table "6. Front axle camber" in the column Degrees (°)/minutes (').
12. Measure the actual values for the front axle camber and enter them.
13. Convert the camber values for the front axle into decimal degrees and enter them into the Decimal degrees (°) column.

    To help with conversion, use table "4. Conversion table, minutes to decimal degrees". Example: -1° 53' =-1.88°.

14. Calculate the difference value in camber at the front axle and enter it into table "6. Front axle camber" at position 6.1 and 6.2 Difference in camber (DS).

    The difference value is the difference between the specified value and the actual value in decimal degrees (°). i.e. the actual value must be subtracted from the specified value. 

15. Copy the specified caster values for the front axle from the basic data to table "7. Front axle caster" in the column Degrees (°)/minutes (').
16. Measure the actual values for the front axle caster and enter them.
17. Convert the caster values for the front axle into decimal degrees and enter them into the Decimal degrees (°) column.

    To help with conversion, use table "4. Conversion table, minutes to decimal degrees". Example: -1° 46' =-1.77°.

18. Calculate the difference value in caster at the front axle and enter it into table "7. Front axle camber" at position 7.1 and 7.2 Difference in caster (DN).

    The difference value is the difference between the specified value and the actual value in decimal degrees (°). i.e. the actual value must be subtracted from the specified value.