Remove/Install Torsion Bar On Rear Axle - AR32.20-P-0315XG
Model 463.276/277 as of model year 2019
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| Notes on repair work on suspension components | AH00.00-P-0100-01A | ||
| Remove | |||
| 1 | Remove rear torsion bar linkages (1) at torsion bar (3). | AR32.35-P-3329XG | |
| 2 | Remove holders of electrical wiring harnesses on the rear axle on left and right in the area of the torsion bar mount. | ||
| 3 | Unscrew bolts (2). | *BA32.35-P-1007-01A | |
| 4 | Remove torsion bar (3). | ||
| Check | |||
| 5 | Check torsion bar (3) and elastomer bearings (3.1) for wear or damage. | If torsion bar (3) or elastomer bearings (3.1) are damaged ↓ Replace torsion bar (3). |
|
| Install | |||
| 6 | Install in reverse order. |
STABILIZER BAR/TORSION BAR
| Number | Designation | Model 460, 461 Model 463 up to model year 2019 | Model 463 as of model year 2019 | |
|---|---|---|---|---|
| BA32.35-P-1007-01A | Bolt, torsion bar holder to rear axle | Nm | - | 95 |