Remove/Install Front Seat Frame Covers - AR91.10-P-1200GW

Model 463 

as of model year 2013 up to model year 2019 

Outer cover,/model refinement package 2012 

Fig 1: Front Seat Frame Covers Components Location - Model 463 As Of Model Year 2013 Up To Model Year 2019 Outer Cover,/Model Refinement Package 2012

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Risk of injury.  Moving parts can pinch, crush or, in extreme cases even sever extremities.	No parts of the body or limbs should be within the operating area of mechanical components when moving components.	AS00.00-Z-0009-01A
	Risk of injury.  caused by performing testing or repair work on airbag or emergency tensioning retractor units.	Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. When working on these units, disconnect the power supply.	AS91.00-Z-0001-01A
	Notes on performing repair, body work and welding on vehicles with airbags and RTE units		AH91.00-P-0002-01M
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Assessment of airbag and belt tensioner units in accident vehicles		AH91.00-P-0006-01B
	Legal requirements on handling and storing airbags and emergency tensioning retractor units		AH91.00-P-0004-01A
1	Unfasten seat cushion (4) and place to one side with lines connected	Model 463 (except 463.242) as of model year 2013 up to model year 2019 Pay attention to unobstructed movement of electrical wiring harnesses below the seat cushion (4). Otherwise there is a danger that the lines will be damaged. Expose electrical wiring harnesses until the seat cushion (4) can be adequately raised.	AR91.10-P-3310GW
2	Move front seat far enough forward and up to enable the cover (1) to be removed
3	Unclip belt end fitting cover (2) from trim (1)
4	Remove screw of seat belt end fitting	Bolt on belt end fitting	*BA91.40-P-1001-01C
5	Remove seat belt (3) with belt end fitting and place to one side	Do not install seat belt (3) with belt end fitting twisted.
6	Remove screw (5) at rear of seat adjustment mechanism (6)
7	Remove screw (7) at front of seat adjustment mechanism (6)	Please ensure that the tabs (arrows A) of the paneling (1) are correctly seated at the seat adjustment mechanism (6).
8	Unclip trim (1) from catch hooks (arrows B1 to B 7 )	Observe the unclipping sequence.
9	Remove cover (1)
10	Install in the reverse order