Remove/Install Radar Sensor In Rear Bumper - AR54.21-P-0704XG
Model 463
as of Model year 2019
with code EA2 (Blind Spot Monitoring)
Fig 1: Rear Radar Sensors (In Rear Bumper) Components Location - Model 463 As Of Model Year 2019 With Code EA2
| Notes on preventing damage to electronic components due to a magnetic tool | AH54.00-P-0002-01A | ||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Remove the screws (1). | ||
| 2 | Remove splash guard (2). | ||
| 3 | Disconnect the electrical connector (3). | ||
| 4 | Unclip integrated right outer rear bumper radar sensor (B92/6) or integrated left outer rear bumper radar sensor (B92/11) from holder (arrow). | ||
| 5 | Install in reverse order. | ||
| Initial startup | |||
| 6 | Perform initial startup of integrated right outer rear bumper radar sensor (B92/6) or integrated left outer rear bumper radar sensor (B92/11). | ||
| AD00.00-P-2000-04B |