Remove/Install 12V Socket In Trunk - AR54.10-P-0016XG
Model 463
as of Model year 2019
| Remove/install | |||
| 1 | Switch off the ignition and keep the transmitter key outside the transmitter range. | ||
| 2 | Open rear-end doors. | ||
| 3 | Open flap of 12V socket at load compartment cover guide rail at left. | ||
| 4 | Release housing with pliers and pull out of the clamping sleeve until the electrical connector is accessible. | Fig 1 | |
| 5 | Disconnect the electrical connector. | ||
| 6 | Remove housing. | ||
| 7 | Install in reverse order. |