Remove/Install Propeller Shaft - AR41.10-P-0050XGA

Model 463 with engine 176

as of model year 2019

Model 463 with engine 177

as of model year 2019

G13658126

Courtesy of MERCEDES-BENZ USA

	Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities.	No parts of the body or limbs should be within the operating area of mechanical components when moving components.	AS00.00-Z-0009-01A
	Notes on threaded connections fastened using a tightening angle-based tightening process		AH00.00-P-0020-01A
	Remove/install
1	Put transmission into neutral position.
2	Release parking brake.
3	Lift vehicle with lifting platform.		AR00.60-P-1006A
4	Mark position of propeller shaft (1) relative to flanges of rear axle differential (4), transfer case (5) and the direction of installation.	To be able to reproduce the original position when installing components.
5	Operate service brake and remove bolts (2, 3)	Aid of helper required.
		Bolt, propeller shaft to transfer case/rear axle differential	*BA41.10-P-1009-01B
6	Remove propeller shaft (1) downwards.	: Check for correct direction of installation and position of propeller shaft (1).
	Check
7	Check propeller shaft (1) and boots for wear and damage.	If problems occur, ↓ replace drive shaft (1).
8	Install in the reverse order.

PROPELLER SHAFT

Number	Designation			Model 463 as of model year 2019
BA41.10-P-1009-01B	Bolt, propeller shaft to transfer case/rear axle differential	Stage 1	Nm	40
BA41.10-P-1009-01B		Stage 2	∠°	90