Remove/Install Rear-End Door Trim - AR72.20-P-6615XG

Model 463 

as of model year 2019 

Fig 1: Rear-End Door Trim Components Location - Model 463 As Of Model Year 2019

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Remove/install
1	Unclip cover (1) at grab handle (2).	Long wedge	Fig 2
2	Remove the screws (3).
3	Unclip rear-end door trim (4).	Guide long wedge directly to each mounting clip (arrows). Otherwise, the retaining tabs of the mounting clips will break. Check mounting clips for damage, replace if necessary. Long wedge	Fig 2
4	Unclip window lining (5) at left and right lower edges until rear-end door trim (4) can be removed.	Long wedge	Fig 2
5	Remove rear-end door trim (4).
6	Install in reverse order.

Fig 2: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA