Remove/Install Trim At C-Pillar - AR68.30-P-4490XG

Model 463 

as of model year 2019 

Fig 1: Trim At C-Pillar Components Location - Model 463 As Of Model Year 2019

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove the seat belt end fitting of the rear seat belt.		AR91.40-P-0681XG
2	Loosen edge guard (2) in the area of the paneling on the C-pillar (1).	Ensure that edge guard (2) is seated correctly.
3	Unclip cover (3).
4	Remove screw (4).
5	Unclip paneling on the C-pillar (1) downwards from the retaining clamps (5).	If the retaining clamps (5) are damaged, ↓ install new retaining clamps (5).
6	Pull paneling on the C-pillar (1) downwards until the guides (6) are free.
7	Guide seat belt out of the paneling on the C-pillar (1) and remove it.
8	Install in reverse order.