(Milling Switch Opening - AR68.20-P-2030-01B)

Model 140, 170, 202, 208, 210 

as of model year 1990 

Model 463 

as of model year 1990 up to model year 2013 

1. Reposition revolver depth stop (7) at the hand router on a light stop screw (20).

   The stop screws that are permanently set by the manufacturer must not be adjusted, because otherwise, the fixture will be damaged when milling.

   Light stop screw (20) set higher for cover with aluminum plate and plastic reinforcement.

   Light stop screw (24) set lower for cover in wood finish.

   Courtesy of MERCEDES-BENZ USA

2. Switch on hand router and press both grab handles downward up to end stop.

   Tighten grab handle.

3. Quickly guide hand router clockwise (direction of arrow) along the light template on the surface of the fixing and clamping device. Release grab handle.
4. Switch off hand router.

Courtesy of MERCEDES-BENZ USA