Electrical function schematic for starting - PE07.10-P-2701-97DAR
ENGINE 651 as of 3/1/13 in MODEL 212 (except 212.098/298)
| Code: | Designation: | Position: |
|---|---|---|
| 1 | Circuit 50, status | 12G |
| 10 | Rail pressure sensor, signal | 8H |
| 11 | Oil temperature sensor, signal | 8H |
| 12 | Camshaft Hall sensor, signal | 7H |
| 13 | Accelerator pedal sensor, signal | 7G |
| 14 | Fuel injectors, actuation | 4F |
| 15 | Coolant temperature sensor, signal | 11E |
| 16 | Crankshaft Hall sensor, signal | 11F |
| 17 | Fuel pump, actuation | 7B |
| 18 | Circuit 87, status | 7E |
| 2 | Gear range, status | 12F |
| 3 | Starter circuit 50 relay, actuation | 10J |
| 4 | Starter, actuation | 11K |
| 5 | Fuel pump relay, actuation | 4D |
| 6 | Fuel pump, request ON | 8C |
| 6 | Fuel pump, request ON | 10C |
| 7 | Circuit 61, status | 10E |
| 8 | Pressure regulator valve, actuation | 14H |
| 9 | Quantity control valve, actuation | 14K |
| A8/1 | Transmitter key | 20L |
| B1 | Oil temperature sensor | 6K |
| B11/4 | Coolant temperature sensor | 13D |
| B37 | Accelerator pedal sensor | 4H |
| B4/6 | Rail pressure sensor | 7K |
| B6/1 | Camshaft Hall sensor | 4J |
| B70 | Crankshaft Hall sensor | 14D |
| CAN C | Drive train CAN | 9D |
| CAN C | Drive train CAN | 14F |
| CAN E1 | Chassis CAN 1 | 14G |
| Code 421 | 9-speed automatic transmission | 19A |
| Code 427 | 7-speed automatic transmission | 17A |
| Code 494 | USA version | 8G |
| G2 | Alternator | 14A |
| LIN C1 | Drive train LIN | 12B |
| M1 | Starter | 12K |
| M3 | Fuel pump (FP) | 6B |
| N10/1 | Front SAM control unit with fuse and relay module | 2B |
| N10/1kM | Starter circuit 50 relay | 9K |
| N10/1kN | Engine circuit 87 relay | 4E |