Remove/install boost pressure sensor - AR09.41-P-2006OGE
ENGINE 642 in MODEL 207, 212, 218, 222
Shown on ENGINE 642 in MODEL 212.020
| Remove/install | |||
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| 1 | Remove engine cover | ||
| 2 | Remove cover for belt drive | ENGINE 642 in MODEL 207, 212, 218 | |
| 3 | Remove right engine air intake duct upstream of air filter housing | ||
| 4 | Release and detach electrical connection from boost pressure sensor (B5/1) | ||
| 5 | Remove boost pressure sensor (B5/1) | ||
| 6 | Install in the reverse order | ||
| 7 | Connect STAR DIAGNOSIS, read out fault memory and clear if necessary | When replacing the boost pressure sensor (B5/1) | |
| ENGINE 642 in MODEL 222 | AD00.00-P-2000-04B | ||
| ENGINE 642 in MODEL 207, 212, 218 | AD00.00-P-2000-04A |