Wiring diagram for FlexRay gateway control unit - PE54.21-P-2143-97DAA
MODEL 212 as of model year 2014 Control unit N93/7
| Code: | Designation: | Position: |
|---|---|---|
| A0 | Color code key | 32L |
| A40/13 | Stereo multifunction camera | 23L |
| CAN E1 | Chassis CAN 1 | 6K |
| CAN E2 | Chassis CAN 2 | 10K |
| N10/1 | Front SAM control unit with fuse and relay module | 18L |
| N10/1f13 | Fuse 13 | 16L |
| N10/2 | Rear SAM control unit with fuse and relay module | 3L |
| N10/2f79 | Fuse 79 | 2L |
| N62/1 | Radar sensors control unit | 13L |
| N93/7 | Chassis gateway control unit | 4A |
| N93/7 | Chassis gateway control unit | 12A |
| N93/7 | Chassis gateway control unit | 20A |
| R50 | Auxiliary heater heating element | 20L |
| W15/1 | Right footwell ground point | 24G |
| W15/2 | Left footwell ground point | 2E |
| X30/26 | Vehicle floor chassis CAN 2 (CAN E2) potential distributor electrical connector | 10L |
| X30/30 | Vehicle floor chassis CAN voltage distributor electrical connector | 6L |
| Z7/19 | Circuit 30 (fused) connector sleeve | 1E |