Make cutout for tablet PC mount holder - AZ82.80-P-0003-07EW

MODEL 212.0##/2## 1#, 218.3##/9## 1# 

The following operation steps are shown on the right side of the vehicle and can be accomplished analogously on the left side of the vehicle.

1. Cut out cutting template (11) along broken line.

   The cutting template (11) is included in the installation kit.

   Fig 1: Tablet PC Mount Holder Template Cutting Line

   Courtesy of MERCEDES-BENZ USA
2. Apply cutting template (11) to head restraint and mark separating point (broken line).
3. Remove cutting template (11).
   Fig 2: Applying Cutting Template To Head Restraint

   Courtesy of MERCEDES-BENZ USA
4. Cut seat cover using a knife and fix shackle (12) in place using adhesive tape (13).
5. Work out opening in seat cover and remove remaining foam.
6. Work out seat core until cross strut (14) of seat is accessible.
7. Fold shackle (12) into opening.
   Fig 3: Shackle, Adhesive Tape And Cross Strut

   Courtesy of MERCEDES-BENZ USA