Retrofit phone bracket - AN82.70-P-0001-02EW
MODEL 212.### 1# without CODE 279 (Electronic gear selector)
- Connect black 4-pin connector (10) of adapter line (4) to Bluetooth module (A34/7) (arrow A).
- Clip Bluetooth module (A34/7) into bracket (3).
- Route antenna line (11) and adapter line (4), as shown, in supports (arrows B) of bracket (3).
- Screw Bluetooth module (A34/7) to bracket (3) with screw/bolt (12).
- Fold over and lock cover (3.1) of bracket (3).
- Create passage (arrow C) in stowage compartment of center console (2).
The passage is pre-stamped in the stowage tray of the center console (2) and can be broken out.
- Route antenna line (11) and adapter line (4) through opening created in center console (2) and place bracket (3) with Bluetooth module into stowage compartment of center console (2).
- Position bracket (3) in stowage compartment of center console (2) and clip catch hook (3.2) into cutouts (arrows D) in center console (2).
Do not clamp the antenna line and the adapter line. Otherwise damage may occur.
The bracket (3) must be positioned in the rear area (arrow E) of the center console (2), as shown.
- Clip cover (13) to Bluetooth module (A34/7).