Remove/install taillamp - AR82.10-P-4905EW

MODEL 212.0/1 

MODEL 212.2 

Shown on model 212.0 

Fig 1: Taillamp Remove/Install Components - Shown On Model 212.0

Courtesy of MERCEDES-BENZ USA

	Risk of injury  caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Notes on sensor system for trunk lid opening/closing		AH80.61-P-0001-01A
	Remove/install
1	Open left or right service flap (1)
2	Unhook bracket (7) from luggage net (8) from right side paneling (2)	MODEL 212.0/1 When removing right rear lamp unit (E4)
3	Lift right side paneling (2) to one side until nuts (4, 5, 6) are accessible	MODEL 212.0/1 When removing right rear lamp unit (E4)
4	Disconnect electrical connector (3) from left rear lamp unit (E3) or right rear lamp unit (E4)	MODEL 212.0/1
5	Detach soundproofing under left or right service flap (1)	MODEL 212.2 Until nuts (4, 5, 6) are accessible.
6	Remove foam material above nut (4) and stop plug above nut (5)	MODEL 212.2
7	Unscrew nuts (4, 5, 6)	To ensure that left rear lamp unit (E3) or right rear lamp unit (E4) is seated correctly, the nuts (4, 5, 6) must be tightened in the following tightening sequence: Nut (4) Nut (5) Nut (6)
8	Detach left rear lamp unit (E3) or right rear lamp unit (E4) and disconnect electrical connector (3)	MODEL 212.2
9	Remove left rear lamp unit (E3) and right rear lamp unit (E4)
10	Install in the reverse order