LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2016 >> E400 Base, 2D Convertible >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Electrical System - Body - 212 Chassis - 1 Of 8 >> Basic Knowledge >> Exterior lights, function >> Exterior lights, function - GF82.10-P-0003FL

Exterior lights, function - GF82.10-P-0003FL

MODEL 212.0/2 up to 28.2.13 

Function requirements, general 

Exterior lights (ABL), general 

The exterior lights control all the safety and comfort-relevant functions of the front, side and rear lights of the vehicle.

The exterior lights system includes the following subfunctions:

Further subfunctions are described in separate documents:

Function sequence for on-board electrical system increase 

When the on-board electrical system voltage is decreased by the on-board electrical system management below the minimum voltage of a light function during normal driving operation, the front SAM control unit with fuse and relay module (N10/1) can suppress shutoff of the corresponding light function with the aid of the on-board electrical system increase. For this purpose, the front SAM control unit requests the minimum voltage necessary for the corresponding light function. The lighting functions for which the on-board electrical system increase is to be activated are defined during production.

The following functions can be coded:

Function sequence for switching off the exterior lights 

Switching off the exterior lights prevents the on-board electrical system battery (G1) from being discharged by the active low beam and standing light actuation.

The low beams may be switched on because of the auto on/off headlamps, the daytime running lights or manually via the exterior lights switch (S1).

A prerequisite for this is that the status of circuit 15 is On.

If circuit 15 is Off, the low beams are switched off.

The standing lights may be on due to the low beams having been manually switched on, due to the auto on/off headlamps or the daytime running lights, or they can be switched on manually via the exterior lights switch.

If the standing lights are activated due to the manual switching on the low beams, the auto on/off headlamps or the daytime running lights and the driver door is then opened with a circuit status of circuit 15C On, the standing lights are switched off.

If the standing lights have been manually switched on (exterior lights switch set to the "standing lights" position), in vehicles up to 31.5.11 they are not switched off.

In vehicles as of 1.6.11 the standing lights are switched off when the on-board electrical system management determines that the engine's starting capability is impaired through the discharged on-board electrical system battery.

IMPORTANT If the "Ambient illumination" function has been activated via the instrument cluster (A1), it automatically switches itself on when the engine is turned off. The standing lights remain switched on for an adjustable time interval of no more than t = 60 s.

The "Ambient illumination" function is described in the "Headlamp switch-off delay (SWA) function" document.

  Exterior lights, location of components   GF82.10-P-0003-02FL 
  Block diagram of exterior lights   GF82.10-P-0003-03FL 
  Standing/parking lights actuation, function   GF82.10-P-3060FL 
  Headlamp control, function Without code (615) Bi-xenon headlamp unit with integrated curve illumination and without code (616) Bi-xenon headlamp unit with integrated asymmetrical curve illumination and without code (621) Intelligent Light System (left-hand traffic) and without code (622) Intelligent Light System (right-hand traffic) GF82.10-P-2009FL 
With code (615) Bi-xenon headlamp unit with integrated curve illumination or code (616) Bi-xenon headlamp unit with integrated asymmetrical curve illumination or code (621) Intelligent Light System (left-hand traffic) or code (622) Intelligent Light System (right-hand traffic) GF82.10-P-2009FLA 
  Additional functions for driving lights actuation, function With code (615) Bi-xenon headlamp unit with integrated curve illumination or code (616) Bi-xenon headlamp unit with integrated asymmetrical curve illumination or code (621) Intelligent Light System (left-hand traffic) or code (622) Intelligent Light System (right-hand traffic) or code (608) Adaptive Highbeam Assist GF82.10-P-3050FL 
  Front fog light actuation, function   GF82.10-P-3070FL 
  Turn signal light actuation, function   GF82.10-P-3008FL 
  Brake lights actuation, function   GF82.10-P-3010FL 
  Backup light actuation, function   GF82.10-P-3011FL 
  Headlight switch off delay, function   GF82.10-P-2011FL 
  Emergency light actuation, function   GF82.10-P-3013FL